Items where Author is "Che Haron, Che Hassan"

Group by: Item Type | No Grouping
Jump to: Article
Number of items: 11.

Article

(2021) Microstructure and microhardness alterations of inconel 718 under cryogenic cutting / Che Hassan Che Haron … [et al.]. Journal of Mechanical Engineering (JMechE), 8 (2). pp. 51-64. ISSN (eISSN):2550-164X

(2020) Optimization of tool life and surface roughness for hypereutectic Al – si alloys in face milling / Kamal Othman...[et al.]. Journal of Mechanical Engineering (JMechE), 17 (2). pp. 27-44. ISSN 1823-5514 ; 2550-164X

(2019) Prediction of cutting force for milling of inconel 718 under cryogenic condition by response surface methodology / Nurul Hayati Abdul Halim...[et al.]. Journal of Mechanical Engineering (JMechE), 16 (1). pp. 1-16. ISSN 1823-5514 ; 2550-164X

(2017) The Correlation Between Tool Wear and Vibration Signals from Piezoelectric in End Milling of AISI P20+NI / Nurul Hidayah Md Tahir...[et al.]. Journal of Mechanical Engineering (JMechE), SI 3 (2). pp. 49-62. ISSN 18235514

(2017) Evaluation of Hole Performance and Force Magnitude on Drilling Parameter for Orthopaedic Surgical Bone Drilling / Noorazizi Mohamad Samsuddin ...[et al.]. Journal of Mechanical Engineering (JMechE), SI 3 (2). pp. 37-47. ISSN 18235514

(2017) Evaluation of Thrust Force in Drilling of Woven Kenaf Fiber Reinforced Epoxy Composite Laminates / Suhaily Mokhtar...[et al.]. Journal of Mechanical Engineering (JMechE), SI 3 (1). pp. 148-168. ISSN 18235514

(2017) Mechanical Properties of Compression Molded Epoxy Polymer Composites Reinforced with Kenaf Fibers / Nur Farhani Ismail ...[et al.]. Journal of Mechanical Engineering (JMechE), SI 3 (2). pp. 1-12. ISSN 18235514

(2017) A Study on Parameter Optimization of the Delamination Factor (Fd) in Milling Kenaf Fiber Reinforced Plastics Composite Materials Using DOE Method / Azmi Harun...[et al.]. Journal of Mechanical Engineering (JMechE), SI 3 (1). pp. 211-224. ISSN 18235514

(2017) TRIZ approach for designing a new assisted tooling for dimple structure fabrication / Mohd Nor Azam Mohd Dali...[et al.]. Journal of Mechanical Engineering (JMechE), SI 1 (1). pp. 79-90. ISSN 1823-5514 ; 2550-164X

(2017) Tool Wear Condition Monitoring using Slip Ring and Accelerometer System in Milling AISI P20 Tool Steel / Wan Nuha Wan Mansor...[et al.]. Journal of Mechanical Engineering (JMechE), SI 3 (2). pp. 63-72. ISSN 18235514

(2017) A review of the milling process to fabricate a dimple structure / Sharudin Hassan...[et al.]. Journal of Mechanical Engineering (JMechE), SI 1 (1). pp. 175-192. ISSN 1823-5514 ; 2550-164X

This list was generated on Thu May 19 05:17:29 2022 UTC.