Items where Subject is "Aircraft"

[up] Up a level
Group by: Creators | Item Type
Jump to: A | B | H | I | K | M | N | R | S | T | W | Z
Number of items at this level: 40.

A

Abd Mukti, Shahrul Nizan (2022) Photogrammetric low-cost unmanned aerial vehicle for pothole detection mapping / Shahrul Nizan Abd Mukti. PhD Thesis , Universiti Teknologi MARA (UiTM) . Digital copy available at UiTM Library Terminal Digital copy available through PERMATA

Abdul Manap, Azli and Hashim, Hussin (2000) Maintenance of fuel spray nozzle in fuel component workshop MAS Aerotechnologies Sdn Bhd / Azli Abdul Manap and Hussin Hashim. [Student Project] (Unpublished) Physical copy available on shelf

Abdul Rahman, Wan Arma Idayu (2002) The analysis of SME MD3 - 160 aircraft wing structure / Wan Arma Idayu Abdul Rahman. Degree Thesis , Universiti Teknologi MARA . Digital copy available at UiTM Library Terminal

Abdullah, Mohd Fakhrulrazi and Alias, Ahmad Jais and Ab. Wahab, Amir Hisham and Ibrahim, Izmuddin and Harun, Ahmad Shubli (2006) The occurrence of bird-strike on aircraft: a preliminary study / Mohd Fakhrulrazi Abdullah …[et al.]. In: Volume No. 1: Science and Technology , 30 – 31 May 2006 , Swiss Garden Resort & Spa Kuantan, Pahang .

Ahmad Shah, Shahrul and Harun, Mohd Khir and Mokhtar, Ahmad Zahir and Alias, Ahmad Jais and Sufian, Maz Amir (2006) The implementation of RFID in aviation industry: a preliminary study on the technological aspect / Shahrul Ahmad Shah …[et al.]. In: Volume No. 1: Science and Technology , 30 – 31 May 2006 , Swiss Garden Resort & Spa Kuantan, Pahang .

Alias, Ahmad Jais and Yatiban, Nasrul Kamil and Salleh, Ramzu and Mohamad, Nor Amidi and Ahmad Shah, Shahrul (2006) Advances in aircraft cabin atmospheric control systems / Ahmad Jais Alias …[et al.]. In: Volume No. 1: Science and Technology , 30 – 31 May 2006 , Swiss Garden Resort & Spa Kuantan, Pahang .

Alshalabi, O. and Mohd Kamal, N. L. and Sahwee, Z. and Ahmad Shah, S. and Norhashim, N. (2023) UAV-enhanced coverage analysis for cellular networks at various altitudes. APS Proceedings , 8 (1) : 27 . pp. 188-192. ISSN 003428568-X.

Amkaromi, Amiruddin (2005) To study and simulate the concept of ramjet / Amiruddin Amkaromi. Degree Thesis , Universiti Teknologi MARA . Digital copy available at UiTM Library Terminal

Azmi, Intan Nabina (2022) Identification of feasible flying pattern of drone for victim identification in remote disaster area / Intan Nabina Azmi. Masters Thesis , Universiti Teknologi MARA (UiTM) .

B

Bakar, Abu Zaid and Dahri, Khairul (2006) Payload characteristics related to mission profile of unmanned aerial vehicle systems: a preliminary study / Abu Zaid Bakar and Khairul Dahri. In: Volume No. 1: Science and Technology , 30 – 31 May 2006 , Swiss Garden Resort & Spa Kuantan, Pahang .

H

Hairuddin, Muhammad Asraf (2021) RISE: Drone and precision agriculture technology for pineapple plantation / Dr Muhammad Asraf Hairuddin. RISE: Catalysing Global Research Excellence , 1 : 3 . p. 18. ISSN 2805-5883.

Hartono, M. Adhitya (2024) Aircraft performance simulation of 19-passenger commuter aircraft: a comparison between normal and amphibious category / Hartono, M. Adhitya. Journal of Mechanical Engineering (JMechE) , 21 (2) : 4 . pp. 51-68. ISSN 1823-5514 ; 2550-164X.

Harun, Mohd Khir and Mokhtar, Ahmad Zahir and Ahmad Shah, Shahrul and Alias, Ahmad Jais (2006) RFID technology for aerospace supply chain: application perspectives / Mohd Khir Harun …[et al.]. In: Volume No. 1: Science and Technology , 30 – 31 May 2006 , Swiss Garden Resort & Spa Kuantan, Pahang .

Hussin, Noor Shuhada (2004) Develop a remote control aircraft for crop spraying / Noor Shuhada Hussin. Degree Thesis , Universiti Teknologi MARA . Digital copy available at UiTM Library Terminal Physical copy available on shelf

I

Ismail, Noor Iswadi and Basri, M. Hisyam and Amir, Muhammad Amirul Hakim and Ab Hamid Pahmi, Muhammad Arif and Rabilah, Rosniza and Mohammud, Mohd Mahadzir (2025) Design and experimental evaluation of a tilt-angle propeller test rig for vertical thrust characterisation of the TRQ-1 quadcopter. Journal of Applied Engineering Design & Simulation (JAEDS) , 5 (2) : 4 . pp. 34-47. ISSN 2805-5756.

K

Khyasudeen, Muhammad Farris (2025) Development of a dynamic adaptive controller for an autonomous unmanned aerial vehicle precision landing system on a moving platform. PhD Thesis , Universiti Teknologi MARA (UiTM) . Digital copy available at UiTM Library Terminal

M

Mahmud, Nor Laili (2022) Sliding mode control design using linear matrix inequality for unmanned aerial vehicle / Nor Laili Mahmud. PhD Thesis , Universiti Teknologi MARA (UiTM) . Digital copy available at UiTM Library Terminal

Md Azian, Afizah (2003) Human factors analysis on Cessna 402B (visual display terminal and cockpit workplace design) / Afizah Md Azian. Degree Thesis , Universiti Teknologi MARA (UiTM) . Physical copy available on shelf

Md. Zin, Mohd. Nor Azman and Abdullah Hashim, Anuar (2000) Maintenance management of aircraft component in component overhaul Department of Masa Sdn.Bhd / Mohd. Nor Azman Md. Zin and Anuar Abdullah Hashim. [Student Project] (Unpublished) Physical copy available on shelf

Mohd Kahar, Muhammad Syafiq Aiman (2026) Efficient modelling and accurate analysis of the dynamic behaviour of a Hi-Lok fastened structure. Masters Thesis , Universiti Teknologi MARA (UiTM) . Digital copy available at UiTM Library Terminal

Mohd Kamil, Ahmad Fadzli and Mohd Nazran, Azmi and Mohd Sani, Shahrizal Izzat (2002) Composite material on the aircraft structure / Ahmad Fadzli Mohd Kamil, Azmi Mohd Nazran and Shahrizal Izzat Mohd Sani. [Student Project] Faculty of Mechanical Engineering. (Unpublished) Digital copy available at UiTM Library Terminal Physical copy available on shelf

Mohd Nasir, Rizal Effendy and Kuntjoro, Wahyu (2013) Stability augmentation for longitudinal modes of a small blended wing-body aircraft with canard as control surface / Rizal Effendy Mohd Nasir and Wahyu Kuntjoro. Journal of Mechanical Engineering (JMechE) , 10 (2) . pp. 37-51. ISSN 1823-5514 ; 2550-164X.

Mohd Razali, Razlin (1999) The efficiency of stuffing and unstuffing operation at CFS 2: KPM. [Student Project] (Unpublished) Digital copy available at UiTM Library Terminal

Mohd Sabri, Natassya Ezzaty (2025) Drone in disaster victim identification: optimising and characterising the efficiency, and DNA profiling in drone-assisted versus conventional procedures. Masters Thesis , Universiti Teknologi MARA (Kampus Sg. Buloh) .

Mohd Suffian, Mohd Harridon (2006) Equipment condition monitoring system of grounded aircraft propeller engine: a prototype semi-manual system / Mohd Harridon Mohd Suffian. In: Volume No. 1: Science and Technology , 30 – 31 May 2006 , Swiss Garden Resort & Spa Kuantan, Pahang .

Mohd Tarmizi, Anis Izzaty (2025) Aero Malaysian Engineering Centre (AMEC). Industrial Training. Faculty of Business and Management . (Unpublished) Digital copy available at UiTM Library Terminal

Mohd Zain, Zairulaily and Ahmad, Zainon (1997) Material failure in aircraft industry / Zairulaily Mohd Zain and Zainon Ahmad. [Student Project] (Unpublished) Physical item is being processed

Mohd. Nasir, Mohd. Nasir and Omar, Zamri (2026) Aerodynamics and longitudinal static stability of a blended wing body aircraft with canard and twin tail boom configuration at low Reynolds numbers via Vortex Lattice computations. Journal of Mechanical Engineering (JMechE) , 23 (3) : 5 . pp. 94-110. ISSN 2550-164X.

Mohd. Zain, Mohd. Nizam and Tahir, Mohd. Nazirudin (2000) Advanced composite materials in aircraft applications / Mohd. Nizam Mohd. Zain and Mohd. Nazirudin Tahir. [Student Project] (Unpublished) Physical copy available on shelf

N

Nasir, Ahmad Nazri and Ariffin, Ruszaini (2000) The study of the aircraft navigation systems: radio navigation system as a model / Ahmad Nazri Nasir and Ruszaini Ariffin. [Student Project] (Submitted) Physical copy available on shelf

Nik Mohd Yusoff, Nik Nur Ilyana and Hassan, Noor Farhana (2015) Transkrip wawancara bersama Profesor Madya Dr. Hanapi Haji Mohd Nor pensyarah dan bapa kepada mangsa tragedi MH17 (Ahmad Hakimi Bin Hanapi) / Nik Nurin Ilyana Nik Mohd Yusoff and Noor Farhana Hassan. Universiti Teknologi MARA, Kelantan . (Unpublished)

Nik Mustapa, Nik Muhammad Muzammil (2016) An aerodynamic performance of MAV wings / Nik Muhammad Muzammil Nik Mustapa. [Student Project] (Unpublished) Digital copy available at UiTM Library Terminal Physical copy available on shelf

R

Ramly, Ramzyzan (2005) Stress analysis of riveted and bonded patch repairs on a stiffened panel / Ramzyzan Ramly. Masters Thesis , Universiti Teknologi MARA . Digital copy available at UiTM Library Terminal

Roszaini, Nurul Farhana and Othman, Siti Amira and Gapor, Aina Ashyiqin and Chong, Pu En and Mohamad, Nurzafirah (2023) Carbon fiber for consumer applications. APS Proceedings , 4 (1) : 2 . pp. 7-12. ISSN 003428568-X.

S

Samiran, Mastuni and Mohd Yahya, Mohd Fitri (2000) Increasing strength of aircraft repaired parts / Mastuni Samiran and Mohd Fitri Mohd Yahya. [Student Project] (Unpublished) Physical copy available on shelf

Sarmin, Shahliza Azreen (2025) Evaluation of aircraft cabin ventilation through inlet/outlet modifications: a computational study of airflow and contaminant dispersion in a generic scaled-down empty aircraft cabin. PhD Thesis , Universiti Teknologi MARA, Shah Alam . Digital copy available at UiTM Library Terminal

Syed Hassan, Syed Khomeini and Abd Rahman, Abd Manan (2004) Propeller test stand / Syed Khomeini Syed Hassan and Abd Manan Abd Rahman. [Student Project] Faculty of Mechanical Engineering. (Unpublished) Digital copy available at UiTM Library Terminal

T

Tuan Mohd Zawawi, Syed Muhamad Syakir (2014) Physical fitness profile among aviation cadets in Malaysia / Syed Muhamad Syakir Tuan Mohd Zawawi. [Student Project] (Unpublished) Digital copy available at UiTM Library Terminal Physical copy available on shelf

W

Wahid, Nurbaiti and Ali, Mohd Aldrin and Mukahar, Nordiana (2012) Modelling and control for longitudinal dynamics of aircraft system / Nurbaiti Wahid, Mohd Aldrin Ali & Nordiana Mukahar. [Research Report] (Unpublished)

Z

Zakaria, Shukri and Wan Jusoh, Wan Nor Shela Ezwane and Mahamad Basri, Mahamad Hisyam and Daud, Md Razak and Yahaya, Mohamad Irwan (2025) Comparative study of surface quality on flat and curved UHMWPE surfaces using robotic milling. Journal of Applied Engineering Design & Simulation (JAEDS) , 5 (2) : 12 . pp. 126-138. ISSN 2805-5756.

This list was generated on Mon Oct 19 01:37:24 2026 UTC.